Rs-232C] - Panasonic PT-DZ21KU Operating Instructions Manual

has been turned off with the input set to SDI2,
projection will start with the SDI1 input, even when
[STARTUP INPUT SELECT] is set to [LAST USED].

[RS-232C]

Set the communication conditions of the <SERIAL
IN>/<SERIAL OUT> terminal.
1) Press ▲▼ to select [RS-232C].
2) Press the <ENTER> button.
▶
z The [RS-232C] screen is displayed.
3) Press ▲▼ to select an item.
■ To set the communication ▶
condition of the <SERIAL IN>
terminal
4) Select [(IN) BAUDRATE] in Step 3).
5) Press ◀▶ to switch [(IN) BAUDRATE].
▶
z The setting will change as follows each time
you press the button.
[9600] [19200]
6) Press ▲▼ to select [(IN) PARITY].
7) Press ◀▶ to switch [(IN) PARITY].
▶
z The setting will change as follows each time
you press the button.
[NONE] [EVEN]
■ To set the communication ▶
condition of the <SERIAL OUT>
terminal
4) Select [(OUT) BAUDRATE] in Step 3).
5) Press ◀▶ to switch [(OUT)
BAUDRATE].
▶
z The setting will change as follows each time
you press the button.
[9600] [19200]
6) Press ▲▼ to select [(OUT) PARITY].
7) Press ◀▶ to switch [(OUT) PARITY].
▶
z The setting will change as follows each time
you press the button.
[NONE] [EVEN]
[PROJECTOR SETUP] menu
■ To set the response ▶
4) Select [RESPONSE(ID ALL)] in Step 3).
5) Press ◀▶ to switch [RESPONSE(ID
ALL)].
▶
z The setting will change as follows each time
you press the button.
[ON]
[OFF]
6) Press ▲▼ to select [GROUP].
7) Press ◀▶ to switch [GROUP].
▶
z The setting will change as follows each time
you press the button.
[A]
[38400]
[A] to [Z]
8) Press ▲▼ to select [RESPONSE(ID
GROUP)].
[ODD]
9) Press ◀▶ to switch [RESPONSE(ID
GROUP)].
▶
z The setting will change as follows each time
you press the button.
[ON]
[OFF]
Note
[38400] z Refer to "<SERIAL IN>/<SERIAL OUT> terminal"
( page 167) for the <SERIAL IN>/<SERIAL OUT>

terminals and ID transmission in RS-232C.
[ODD]
[ON]
Returns the response when the ID
setting is ALL.
Does not return the response when the
ID setting is ALL.
[B]
Controls multiple projectors
simultaneously by sending the ID of
RS-232C. Set the group from [A] to [Z].
The projector responds when the ID of
RS-232C matches the setting.
[ON]
Returns the response when the ID
setting is GROUP.
Does not return the response when the
ID setting is GROUP.
ENGLISH - 111
[OFF]
[Z]
[OFF]