SECTION 3: CONFIGURATION SETUP
COLOR Model
AUTO / DAY / NIGHT / EXT
—
Delay : 0 ~ 255 second
—
BURST : OFF / ON
—
THRS : LOW / MIDDLE / HIGH
—
GAP : LOW / MIDDLE / HIGH
—
IR SMART Model
AUTO
—
Delay : ---
»
BURST : OFF / ON
»
THRS : ---
»
GAP : ---
»
IR CDS Model
AUTO / DAY / NIGHT
—
Delay : ---
»
BURST : OFF / ON
»
THRS : ---
»
GAP : ---
»
SMART IR : OFF / ON. NOTE: SMART IR function only works with IR Smart Model.
•
THRS : Set-up Smart IR turns on point. When you level up the value, Smart IR turns on in a low light condition.
—
AREA : Set up areas to control Smart IR function. When BLC mode is on, Smart IR area is following BLC area.
—
POS-X : Adjust the window X-Axis position
—
POS-Y : Adjust the window Y-Axis position
—
SIZ-X : Adjust the window X-Axis size
—
SIZ-Y : Adjust the window Y-Axis size
—
IR COMP : Compensate for IR fluctuations. When you use this function, put a test object 12 in (30 cm) from the
—
camera. If an object is located nearer than 12 in and an object that could reflect light is in front of the camera, the
camera cannot compensate for the fluctuations.
8
IR SMART OFF
IR SMART ON