Advertisement
Quick Links
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for skyangel T-33
Summary of Contents for skyangel T-33
- Page 1 Assembly and Operating Manual...
- Page 3 The radio control system Glued joints, suitable adhesives Congratulations on your choice of a To fly the T-33 you will need a radio control Foam safe epoxy is recommended and available factory-assembled model aircraft from the system with at least four channels. 2.4GHz radios from most reputable model retail shops.
-
Page 4: Parts Illustration
Assembly and Operating Manual T-33 Fig. 1 Open the box and check all the parts. Parts Illustration Parts List Description Fuselage Wing Set – One Main Wing Panel Tail Set - One Left (and one Right) Horizontal Stabilizer with Elevator... - Page 5 Assembly and Operating Manual T-33 Fig. 2 - Glue the horizontal stabilizers to the slots Fig. 3 - Remove any excess glue and hold in Fig. 4 - Connect the push rods to the elevator at the rear of the fuselage (glue not included).
- Page 6 Assembly and Operating Manual T-33 Fig. 8 - Insert the aileron servo wire into the Fig. 9 - Insert the wing panel to the fuselage. Fig. 10 - Attach the white fix base to the fuselage fuselage. as photos shown.
- Page 7 Assembly and Operating Manual T-33 Fig. 14 - Tighten the main wing with screws. Fig. 15 - Glue the vertical stabilizer as shown in Fig. 16 - Connect the electronic speed controller the photo (glue not included). and servos to the receiver. Refer to the radio instructions for the correct channel sockets and servo lead polarity.
- Page 8 Assembly and Operating Manual T-33 Fig. 20 - The canopy is held in place by magnets and can be lifted off. Fig. 22 - Charge the flight battery; connect the Equalizer lead using and adapter lead matching your charger (adapter lead not included).
- Page 9 Assembly and Operating Manual T-33 - Check that the control surfaces respond to the appropriate movements of the transmitter sticks. If not, swap over the connectors at the receiver. - Check the neutral position of the control surfaces; you may need to screw the clevises in or out to correct any discrepancy.
- Page 10 Assembly and Operating Manual T-33 Fig. 27 - Checking the model’ s balance - Place the flight battery in its compartment, without connecting. - Mark the Centre of Gravity (CG) on both sides of the fuselage; the position is shown in the photo.
- Page 11 Switch the motor on, and launch the airplane strongly into the wind, with the fuselage and wings level. Allow the T-33 Jet to fly straight and level initially; don’ t try to turn it when it is close to the ground.
- Page 12 Jiangyin Skyangel Electronic Technology Co., Limited. 5th Floor, A3 Building, Xinjianxing Technology Industrial Park, Fengxin Road, Guangming Town, Bao'an, Shenzhen City, 518107 China Phone: +86 755 33699201 Fax: +86 755 33699203 www.skyangelrc.com...
Need help?
Do you have a question about the T-33 and is the answer not in the manual?
Questions and answers