Useful Tips - Binatone SI-4016 Instruction Manual

this function perform the following procedure:
1. Set the steam control knob (9) into the "0" position.
2. Fill the tank (5) with water to the "Мах" level.
3. Place the iron in a vertical position and plug it into the mains
supply outlet.
4. Set the temperature control knob (10) into the "Max" posi
tion. The temperature indicator (12) will light up showing that
the iron is being heated to the desired temperature.
5. When the iron reaches the maximum temperature, the indica
tor (12) will go out.
6. Disconnect the iron from the main supply outlet. Whilst hold
ing the appliance horizontally over a sink, press the self
clean knob "Self Clean" (6). Hot steam will discharge from
the sole plate (13) removing the scale and dust
7. When the water tank (5) is completely empty, release the
self clean knob (6).
8. Put the appliance into a vertical position and re heat the iron.
9. To complete the cleaning process; Iron a piece of a clean old
cotton cloth in order to clean the sole plate (13) of any re
maining dust and scale and to evaporate the remaining water.
When you have finished ironing, always switch the appliance
off and disconnect from the electrical supply.
Storage
Before storing the iron, make sure it is disconnected from the
mains supply outlet and is completely cooled down. Set the tem-
perature control knob into the "Min" position and the steam
control knob into the "0" position. Drain the remaining water from
the tank (5) by opening the cover (4) and holding the iron upside
down over the sink. Store the appliance in the upright standing
position.

USEFUL TIPS

Selection of temperature settings
Before ironing, we recommend that you or-
ganize your clothes, into the types of material
and the recommended temperature settings.
We recommend that you start ironing, using
the lower temperature settings first: the appliance
gets hot quicker than it cools down.
When ironing articles made with combinations of fibers, start
with the temperature recommended for the most delicate ma-
terial first (for example, to iron a cloth made of cotton and
polyester select the temperature recommended for ironing
polyester first).
If the manufacturer's label, which gives the recommended
temperature, is missing and the type of material is known,
follow the recommendations below.
7