Table of Contents
Advertisement
button (8)
(8)
(8)
(8) to produce a directional strong burst of steam from
(8)
the sole plate. Push the button several times with 5–7 seconds
intervals until the article is fully refreshed.
! If during the process your water tank (5)
disconnect the appliance from the mains outlet, wait till it cools
down, refill the tank and plug the appliance back into the
power supply and continue the process.
Using the water spray (7)
article (cuffs, trimmings, plackets, etc) or clothes, which demand
"•" (low temperature) ironing, when steam ironing is not possible.
Push the button several times to moisten the material.
5. When you have finished cleaning or ironing, do not forget to
switch the iron off by putting the steam control knob (9)
the "0" position, the temperature control knob (10)
"Min" position and unplugging the appliance from the mains
supply outlet.
CARE AND MAINTENANCE
! The scale on the sole plate can be removed
! Do not use any abrasive substances and ma-
Before storing the iron, make sure it is disconnected from the
mains supply outlet and is completely cooled down. Set the tem-
perature control knob into the "Min" position and the steam control
knob into the "0" position. Drain the remaining water from the
(5)
(5)
tank (5)
(5)
(5) by opening the cover (4)
down over the sink. Store the appliance in the upright standing
position.
USEFUL TIPS
Selection of temperature settings
! Before ironing, we recommend that you orga-
! We recommend that you start ironing, using the
! When ironing articles made with combinations of fibers, start
with the temperature recommended for the most delicate mate-
rial first (for example, to iron a cloth made of cotton and polyes-
ter select the temperature recommended for ironing polyester
first).
Spray
(7)
(7)
(7) will help when ironing details of the
(7)
Cleaning of the sole plate
with a rough cotton cloth dampened with a
vinegar solution.
terials to clean the sole plate.
Storage
(4)
(4)
(4)
(4) and holding the iron upside
nize your clothes, into the types of material and
the recommended temperature settings.
lower temperature settings first: the appliance
gets hot quicker than it cools down.
6 6 6 6 6
(5) runs out of water,
(5)
(5)
(5)
(9)
(9)
(9) into
(9)
(10) – into the
(10)
(10)
(10)
Advertisement
Table of Contents
