Table of Contents
Advertisement
Warning: In areas with very hard water it is recommended
that you regularly remove scale from the appliance to
maintain it in good working order. Excess lime scale
may result in damage or malfunction of your product.
If in your area the water is soft and you have average amounts
of clothes to be ironed then we recommend you to de-scale every 6
months. If the water in your area is very hard or if you iron fre-
quently, then we recommend you de-scale once a month.
Your iron has a self-cleaning function, which allows you to clean
the internal parts of the appliance from scale or dust. To use this
function perform the following procedure:
1. Set the steam control knob (9)
2. Fill the tank (5)
(5)
(5) with water to the «Max» level.
(5)
(5)
3. Place the iron in a vertical position and plug it into the mains
supply outlet.
4. Set the temperature control knob (10)
The light indicator (11)
being heated to the desired temperature.
5. When the iron reaches the maximum temperature, the light
(11)
(11)
indicator (11)
(11) will go out.
(11)
6. Whilst holding the appliance horizontally over a sink, set the
steam control knob (9)
steam will discharge from the sole plate (12)
scale and dust. If the blast of steam becomes weaker, set the
control knob (9)
(9)
(9) into the «0» position and wait for 12-15
(9)
(9)
seconds until the iron gets hot again. Then once again set the
control knob into the «Self-Clean» position.
7. When the water tank (5)
control knob (9)
(9)
(9)
(9) into the «0» position.
(9)
8. Put the appliance into a vertical position and re-heat the iron.
9. To complete the cleaning process; Iron a piece of a clean old
cotton cloth in order to clean the sole plate (12)
ing dust and scale and to evaporate the remaining water. When
you have finished ironing, always switch the appliance off and
disconnect from the electrical supply.
Before storing the iron, make sure it is disconnected from the
mains supply outlet and is completely cooled down. Set the tem-
perature control knob and the steam control knob into the «0»
position. Drain the remaining water from the tank (5)
the cover (4)
(4)
(4)
(4)
(4) and holding the iron upside down over the sink. Store
the appliance in the upright standing position.
Selection of temperature settings
! Before ironing, we recommend that you orga-
! We recommend that you start ironing, using the
(9)
(9)
(9) into the «0» position.
(9)
(10)
(10)
(10)
(10) into the «Max» position.
(11)
(11) will light up showing that the iron is
(11)
(11)
(9)
(9) into the «Self-Clean» position. Hot
(9)
(9)
(5) is completely empty, set the steam
(5)
(5)
(5)
Storage
USEFUL TIPS
nize your clothes, into the types of material and
the recommended temperature settings.
lower temperature settings first: the appliance
gets hot quicker than it cools down.
7 7 7 7 7
(12)
(12) removing the
(12)
(12)
(12)
(12)
(12) of any remain-
(12)
(5)
(5)
(5) by opening
(5)
Advertisement
Table of Contents
