Useful Tips - Binatone SI-2500 Instruction Manual

discharge from the sole plate (12) removing the scale and dust.
If the blast of steam becomes weaker, set the control knob (9)
into the "0" position and wait for 12-15 seconds until the iron
gets hot again. Then once again set the control knob into the
"Self-clean" position.
7. When the water tank (5) is completely empty, set the steam control
knob (9) into the "0" position.
8. Put the appliance into a vertical position and re-heat the iron.
9. To complete the cleaning process, iron a piece of a clean old cotton
cloth in order to clean the sole plate (12) of any remaining dust
and scale and to evaporate the remaining water. When you have
finished ironing, always switch the appliance off and disconnect
from the electrical supply.
Before storing the iron, make sure it is disconnected from the mains
supply outlet and is completely cooled down. Set the temperature
control knob into the "Min" position and the steam control knob into
the "0" position. Drain the remaining water from the tank (5) by
opening the cover (4) and holding the iron upside down over the sink.
Store the appliance in the upright standing position.
Before ironing, we recommend that you organize
your clothes, into the types of material and the
recommended temperature settings.
We recommend that you start ironing, using the
lower temperature settings first: the appliance gets
hot quicker than it cools down.
When ironing articles made with combinations of fibers, start
with the temperature recommended for the most delicate ma-
terial first (for example, to iron a cloth made of cotton and
polyester select the temperature recommended for ironing
polyester first).
If the manufacturer's label, which gives the recommended
Storage

USEFUL TIPS

Selection of temperature settings
8