Operating Instructions - Paramount Fitness PCC2000 Owner's Manual

On all Paramount in-floor cleaning and circulation systems it is important to keep the skimmer, the pump and the debris canister baskets clean. It is
also important to clean your filter when the pressure rises 5 psi (34 kPa) over the clean starting pressure.
The gauge on your water valve is important and tells you how the system is operating. Gauges can deteriorate over time and should be replaced
when they become unreadable or inaccurate.
NOTICE
If a nozzle is stuck open or up when the pump shuts off you may clear it by pushing down on it a few times while pump is on to clear the obstruction.
No cleaning system is 100%. Paramount's in-floor guarantee is the strongest in the industry but some attention to the pool is required to keep your
backyard oasis beautiful. You must keep your chemicals at proper levels, and brush any small areas that may have a build up of heavy sand or debris.
Keep in mind that when excessive debris gets into a pool, such as large amounts of leaves in the fall or dirt during a dust storm, no cleaning system
can do the job without some help, so be sure your equipment is maintained.
On PCC2000 and Vantage systems that may have fixed nozzles they may need to be adjusted to keep their flow of water aimed in the direction of the
debris drain. These nozzles can be turned clockwise when in the up position by pushing down slightly and rotating them towards the main drain.
For further instructions see troubleshooting.

OPERATING INSTRUCTIONS

Never use Teflon tape on a replacement gauge, use a thread sealant that is approved for plastic such as
Teflon paste. Hand tighten gauges as over tightening can crack the water valve lid.
17