RUN/PAUSE CONTROL SWITCH
The run/pause control switch is used to stop the cleaning system circuits
Figure 6
from cycling. When switched to the pause position, it will stop on the
circuit that is up at that time. The run/pause control switch should only be
used when you desire the nozzles not in the up position to remain down or
while servicing the system.
Note: The run/pause control switch can be used without turning off the
pump, but can cause damage to the water valve or module diaphragms
if overused. If you frequently use the run/pause control switch you should
turn off the pump first. Always turn the run/pause control switch to the run
position when removing and replacing the water valve lid.
12