Charging The Receiver Battery; Receiver Battery Installation; Antenna Tube Installation - ProBoat Rockstar 48 Owner's Manual

Charging the Receiver Battery

Instructions
Choose a charger designed to charge the included 7.4V
5200mAh 2S 15C LiPo. We recommend the Dynamite ®
Prophet Sport Li- Po AC Balance Charger (DYNC2005).
Refer to your charger manual for charging instructions
and safety information.

Receiver Battery Installation

1. Remove the 2 clips and the lid from the battery
compartment.
2. Install the battery in the battery compartment.
3. Connect the battery EC3 ™ connector to the R.O.S.S
unit.
4. Install the lid on the box and secure the lid using the
clips.
IMPORTANT: After boating, always remove the battery
before transporting or storing the boat.

Antenna Tube Installation

1. Remove the 3 clips and the 2 lids from the boxes.
2. Remove the set screw using a 1.5mm hex driver and the
antenna tube from the side of the radio box.
3. Feed the antenna through the antenna mount and into
the antenna tube as shown.
4. Install the tube in the antenna mount, then secure the
tube with a 3mm set screw using a 1.5mm hex driver.
5. Replace the lids and clips on the boxes.
6. Guide the antenna tube through the hole in the canopy
and install the cap on the antenna tube.
IMPORTANT: The antenna must be installed above
the boat's waterline to get the best reception of your
transmitter's signal.
RockStar 48
NOTICE: Never charge a battery in the boat or damage
may result.
EN
5