Table of Contents
Advertisement
EN
Contents
2.4GHZ DIGITAL
RADIO SYSTEM
Specifications
Length
17 in (430mm)
6.125 in (156mm)
Beam
Transmitter
STX2 2 CH 2.4 GHz FHSS
Receiver/ESC
2-in-1 Receiver
4 AA batteries (sold separately) are required to operate the transmitter.
Boat Battery Pack Installation
1. Lift the back of the canopy lid off the magnet
and pull it back and away from the hull to remove.
2. Adhere loop tape (included) to the battery.
Do not cover the battery warning label.
3. Connect the battery.
4. Secure the boat battery on the hook strip in the boat.
5. Refer to Getting Started instructions about powering
on your boat.
Charging Warnings
WARNING: Failure to exercise caution
while using this product and comply with
the following warnings could result in product
malfunction, electrical issues, excessive heat, FIRE,
and ultimately injury and property damage.
•
NEVER LEAVE THE BATTERY AND CHARGER
UNATTENDED DURING USE.
•
NEVER CHARGE BATTERIES OVERNIGHT.
• Read all safety precautions and literature prior to use of
this product.
• Never allow children under 14 years of age to charge
battery packs.
• Never attempt to charge damaged batteries.
• Never charge a battery if the cable has been pinched
or shorted.
• Never allow the batteries or charger to come into
contact with moisture at any time.
• Never charge batteries in extremely hot or cold places
(recommended between 50–80°F [10–26°C]) or in
direct sunlight.
4
Hull Material
ABS Plastic
380 Water-Cooled Brushed Motor
Motor
Charger
100mA Wall Charger with EC3 (DYNC1009)
Battery
6-cell 1200mAh Ni-MH battery (DYN1472)
2
• Always use only Ni-MH rechargeable batteries. This
charger cannot charge batteries such as "heavy duty,"
"alkaline," "mercury" or "lithium" batteries.
• Always connect to the charger correctly.
• Always disconnect the battery and charger after
charging and let them cool between charges.
• Always inspect the battery before charging.
• Always terminate all processes and contact Horizon
Hobby if the product malfunctions.
• Always make sure you know the specifications of the
battery to be charged or discharged to ensure it meets
the requirements of this charger.
• Always connect the charge cable to the charger first,
then connect the battery to avoid short circuit between
the charge leads. Reverse the sequence when
disconnecting.
• Always constantly monitor the temperature of the
battery pack while charging.
• Always end the charging process if the charger or
battery becomes hot to the touch or starts to change
form during the charge process.
Recommended Tools
and Materials
• Needle nose pliers
• Paper towel
• Rubbing alcohol
• Temporary threadlock
• Nut driver: 5.5mm
• Phillips screwdriver: #1
• Hex wrench: 2.5mm
• Clear tape (DYNM0102)
• Pro Boat
Marine Grease and
®
Gun (PRB0100)
4
3
Miss GEICO 17
Advertisement
Table of Contents
