Troubleshooting Guide - ProBoat Rockstar 48 Owner's Manual

EN

Troubleshooting Guide

Problem
Boat will not respond
to throttle but responds
to other controls
Extra noise or extra
vibration
Reduced run time or
boat underpowered
Boat will not Bind
(during binding) to
transmitter
Boat will not connect
(after binding) to
transmitter
Boat tends to dive in the
water or takes on water
Boat tends to turn one
direction
Rudder does not move
Controls reversed
Engine overheats
Erratic control
16
Possible Cause
Throttle channel is reversed
Damaged propeller, shaft or engine
Propeller is out of balance
Receiver battery charge is low
Receiver battery is damaged
Blocking or friction on shaft or propeller
Boat conditions may be too cold
Battery capacity may be too low
for conditions
Drive dog is too close to the prop strut
Too little lubrication on flex shaft
Vegetation or other obstacles block
the rudder or propeller
Transmitter is too near boat during
binding process
Boat or transmitter is too close to
large metal object, wireless source
or another transmitter
Receiver battery/Transmitter battery
charge is too low
Receiver switch is off
Transmitter is too near boat during
connecting process
Boat or transmitter is too close to
large metal object, wireless source
or another transmitter
Receiver battery/transmitter battery
charge is too low
Receiver switch is off
The boat hull is not completely closed
Prop angle is incorrect
Rudder or rudder trim is not centered
Rudder, linkage or servo damage
Servo wire is damaged or connections
are loose
Transmitter is not bound correctly
Receiver switch is off
Transmitter settings are reversed
Blocked water cooling system
Transmitter is too near boat during
binding process
Solution
Reverse throttle channel on transmitter
Replace damaged parts
Balance or replace propeller
Completely recharge battery
Replace battery and follow battery instructions
Disassemble, lubricate and correctly align parts
Make sure battery is warm before use
Replace battery or use a larger capacity battery
Loosen drive dog and move out away from the
prop strut a small amount
Fully lubricate flex shaft
Remove vegetation or obstacles from rudder or
propeller
Move powered transmitter a few feet from boat,
disconnect and reconnect battery to boat
Move boat and transmitter to another location and
attempt binding again
Replace/recharge batteries
Power on Receiver switch
Move powered transmitter a few feet from boat,
disconnect and reconnect battery to boat
Move boat and transmitter to another location and
attempt connecting again
Replace/recharge batteries
Power on Receiver switch
Dry out the boat and ensure the hatch is fully
closed on the hull before returning the boat
to the water
Adjust prop angle
Repair rudder or adjust rudder and rudder trim
for straight running when control is at neutral
Replace or repair damaged parts and adjust con-
trols
Do a check of wires and connections, connect
or replace as needed
Re-bind receiver to the transmitter
Power on receiver switch
Do the Control Direction Test and adjust controls
on transmitter appropriately
Clean or replace parts in the water cooling
system
Move powered transmitter a few feet from boat,
disconnect and reconnect battery to boat
RockStar 48