Vehicle Starting And Running; Breaking In The Engine - ProBoat Rockstar 48 Owner's Manual

Vehicle Starting and Running

1. Remove the canopy.
2. Power on your transmitter, then power on the
receiver.
3. Press the priming bulb several times until it becomes
fi lled with fuel. This is not necessary if the engine has
been run recently.
CAUTION: Make sure you understand all engine instructions before attempting to start the engine.
Failure to follow all instructions can lead to damage to your vehicle, property damage and bodily injury.
CAUTION: Always keep all body parts, hair and dangling or loose items away from a spinning propeller, as these
could become entangled.

Breaking in the Engine

Break in the engine by running slowly for the first half
tank of fuel (about 25 minutes).
NOTICE: Do not adjust carburetor settings during
break-in. Doing so will cause engine damage.
When the boat is moving forward, ensure water flows
out of the coolant outlets. If water is not flowing out of
the coolant outlets remove any blockage from the rudder
inlet and coolant system or the engine and tuned muffler
may overheat.
RockStar 48
4. Replace the canopy before placing the boat in the
water.
5. With the boat in the water, press the Bind/R.O.S.S
button on the top of the included transmitter to start
the engine.
EN
9