Ntp Server Settings - HIKVISION DS-7604 User Manual

DVR Domain Name, enter the domain obtained from the DynDNS web site. Finally, enter the
User Name and Password registered in the DynDNS network.
Figure7. DynDNS Settings

NTP Server Settings

A Network Time Protocol (NTP) Server may also be set up on your DVR to maintain accurate current date and
time.
To set up an NTP server:
1. Click Menu > Settings > Network to enter the Network Settings menu.
2. Select the Advanced tab.
3. Click the Set button next to NTP to enter the NTP Settings menu, as shown in Figure 8.
Figure8. NTP Settings Menu
4. Check the NTP checkbox to enable this feature.
5. Configure NTP settings:
• Synchronize Interval: Time in minutes to synchronize with NTP server.
• NTP Server: IP address of NTP server.
6. Click OK to save settings and exit the NTP Settings menu.
Note:
Time synchronization interval has a range of 0-10080ms, normally 7200ms. If the DVR is used on a
public network, you should use a NTP server that has a time synchronization function, such as the server at the
National Time Center (IP Address: 210.72.145.44). If the DVR is setup in a more customized network, NTP
software can be used to establish a NTP server used for time synchronization.
www.cctvireland.ie
60
shop@cctvireland.ie