Toshiba Bar Code Printer Network Tool Operation Manual page 40

Icons Used for Printer Image and LCD Message Display
Icon Status Name
SUPPORTED PRINTERS
Off-line
On-line /
Printing
Saving
Pause
Command error
Communication
error
Memory error
RFID error
Printer error
[Status Value]
********
[Status Value] [H]
LCD Message Display
ON LINE
SAVING
PAUSE
COMMAND ERROR
COMMS ERROR
FLASH WRITE ERR.
FORMAT ERROR
FLASH CARD FULL
RFID ERROR
********
********
40
Description
Printer is not connected or recognized.
Printer is being monitored properly.
Ribbon near end
Remaining amount of ribbon is low.
Writable characters or PC command is being
saved.
Returns to online mode after saving is
completed.
In pause state
An issue is being stopped by the [PAUSE] key.
Pressing the [RESTART] key continues to print.
Ribbon near end
Remaining amount of ribbon is low.
Command error is occurring.
Please send a correct command.
When an error exists in a command sent from a
computer, 16 bytes of the command code of the
applicable command is displayed on the upper
line of the LCD.
Communication error is occurring.
Turn the power switch off/on, or press the
[RESTART] key.
If the same error repeats, contact your local
service station.
Memory error is occurring.
Several causes can be thought of. Handle the
matter with reference to 'Error Message' in
Owner's Manual.
• Write error to flash memory occurred.
• Format error occurred in flash memory.
• Saving failed due to insufficient free space of
flash memory.
RFID communication error is occurring.
Several causes can be thought of. Handle the
matter with reference to 'Error Message' in
Owner's Manual.
• Communication with RFID module is not
available.
• Writing to chip failed.
Printer error is occurring.
• Status value: 36
The voltage of the real time clock battery is
low.
• Status value: Excluding 36
Other hardware/software
occurring.
If the same problem repeats, turn the power off
and consult with your service engineer.
Head broken elements error is occurring.
The result of the head check by the TEC
Barcode Net Admin shows broken dots.
problem is