Configuring Wake-Ups - Symbol PDT 8000 Series Product Reference Manual

PDT 8000 Series Product Reference Guide

Configuring Wake-ups

The terminal can be configured to wake-up by pressing the Trigger key, any key on the
keypad, the key on the headset (if available) or by plugging in the headset. To set up this
configuration:
1. Tap Start - Settings - System tab - Symbol Settings.
2. Use the Wakeups tab to configure the wake-up source for the terminal.
a. Under Power Off select the items to configure wake-ups when the terminal is
powered off.
b. Under Auto Off select the items to configure wake-ups when the terminal goes
into suspension mode after a set period of time (this time can be set in Start -
Settings - System tab - Power).
Note: The Power button is the only wake-up source for the terminal after
the battery door is reinstalled, after a battery fault condition or when
the terminal suspends due to very low battery. Once the terminal is
resumed with the Power button, all selected wake-up sources can
be used, as configured.
1-34
Figure 1-19. Setting Wake-ups