Remote Control Battery Installation; Using The Remote Control Unit - Sanyo PLC-8810E Owner's Instruction Manual

Multimedia projector
Table of Contents

Advertisement

Remove
the battery
compartment

USING THE REMOTE CONTROL UNIT

Point the remote control toward the projector (Receiver window) whenever pressing
range for the remote control is about 5m and 60' front and rear of the projector.
A
To insure safe operation, please observe the following precautions:
l
Use (2) AA, UM3 or R06 type alkaline batteries,
Change two batteries at the same time.
Do not use a new battery with a used battery.
Avoid contact with water.
Do not drop the remote control unit.
If batteries have leaked on the remote control, carefully wipe the case
clean and load new batteries.

REMOTE CONTROL BATTERY INSTALLATION

lid.
Note: For correct polarity (c and -
Slide the batteries into the
compartment.
terminal), be sure the battery
terminals are in contact with
the pins in the compartment.
compart-
ment lid,
the buttons. Maximum operating

Advertisement

Table of Contents
loading

Table of Contents