Connecting To Xdsl/Cable Modem - iCanTek iCanView 240 User Manual

Mpeg-4 speed dome network camera

Table of Contents

iCanView240/250 User's Guide

other IP sharing devices sit in-between the client and the IP video products. For more detailed information

regarding the use of IP sharing device refer to the document

[Use of Private IP network using IP-sharing-

device].

②

3.2. Connecting to xDSL/Cable Modem

1. Please connect iCanView240/250 to PC through Hub and then connect DC power adapter.

2. Install IP-Installer and i-NVR S/W on PC

3. Using IP Installer S/W, set up some parameters for communication through IP network

Please refer to the IP installer and i-NVR user's guide.

4. Connect iCanView240/250 with ADSL/Cable Modem as Fig.3.2

5. Run i-NVR program and check if you can receive video data when connecting to iCanView240/250.

Fig. 3-2 Connecting iCanView240/250 to ADSL/Cable Modem

When fixed IP address is assigned to the xDSL or Cable modem, follow the same way as assigning IP

address for the case of LAN using IP-installer. To enable the notification of the changed IP address to the

Rev.1.0 (Dec.2006)

Table of Contents

Icanview 250