Serial Trigger Commands; Read Time-Out; Resetting The Standard Product Defaults - Honeywell Voyager 1250g User Manual

MAX60[ACK],
DFT[ACK].
This response indicates that the device's Codabar Coding Enable (CBRENA) is
set to 1, or on;
the Start/Stop Character (SSX) is set to 0, or Don't Transmit;
the Check Character (CK2) is set to 0, or Not Required;
concatenation (CCT) is set to 1, or Enabled;
the Minimum Message Length (MIN) is set to 2 characters;
the Maximum Message Length (MAX) is set to 60 characters;
and the Default setting (DFT) has no value.

Serial Trigger Commands

You can activate and deactivate the scanner with serial trigger commands. The
trigger is activated and deactivated by sending the following commands:
Activate: SYN T CR
Deactivate: SYN U CR
The scanner scans until a bar code has been read or until the deactivate com-
mand is sent. The scanner can also be set to turn itself off after a specified time
has elapsed (see

Read Time-Out

Use this selection to set a time-out (in milliseconds) of the scanner's trigger
when using serial commands to trigger the scanner. Once the scanner has
timed out, you can activate the scanner either by pressing the trigger or
using a serial trigger command. After scanning the Read Time-Out bar
code, set the time-out duration (from 0-300,000 milliseconds) by scanning
digits on the
Save. Default = 30,000 ms.

Resetting the Standard Product Defaults

If you aren't sure what programming options are in your scanner, or you've
changed some options and want the factory default settings restored, scan the
Standard Product Default Settings bar code below.
9 - 4
Read Time-Out, which follows).
Programming Chart
Read Time-Out
Standard Product Default Settings
inside the back cover, then scanning