Plessey Message Length - Honeywell Voyager 1250g User Manual

When Check Character is set to Validate and Transmit, the scanner only
reads Plessey bar codes printed with a check character, and will transmit
this character at the end of the scanned data. Default = No Check Charac-
ter.
* No Check Character
Validate and Transmit
Plessey Redundancy
If you are encountering errors when reading Plessey bar codes, you may
want to adjust the redundancy count. Redundancy adjusts the number of
times a bar code is decoded before transmission, which may reduce the
number of errors. Note that the higher the redundancy count, the longer it
will take to decode the bar code. To adjust the redundancy, scan the
Plessey Redundancy bar code below, then scan a redundancy count
between 0 and 10 on the
manual. Then scan the

Plessey Message Length

Scan the bar codes below to change the message length. Refer to
Message Length Description
mum and Maximum lengths = 1-80. Minimum Default = 3, Maximum
Default = 80.
Minimum Message Length
6 - 60
Programming Chart
Save bar code. Default = 0.
Plessey Redundancy
(page 6-2) for additional information. Mini-
Validate, but Don't Transmit
inside the back cover of this
Maximum Message Length