Repairs; Maintenance; Cleaning The Device:; Inspecting Cords And Connectors - Honeywell Voyager 1250g User Manual

11

Maintenance

Repairs

Repairs and/or upgrades are not to be performed on this product. These ser-
vices are to be performed only by an authorized service center (see
Support on page 12-1).
Maintenance
Your device provides reliable and efficient operation with a minimum of care.
Although specific maintenance is not required, the following periodic checks
ensure dependable operation:

Cleaning the Device:

Reading performance may degrade if the scanner's window is not clean. If
the window is visibly dirty, or if the scanner isn't operating well, clean the
window with a soft cloth or lens tissue dampened with water (or a mild
detergent- water solution). If a detergent solution is used, rinse with a
clean lens tissue dampened with water only.
The scanner and base's housing may also be cleaned the same way.
Do not submerge the scanner in water. The scanner's
Do not use abrasive wipes or tissues on the scanner's
window – abrasive wipes may scratch the window. Never
use solvents (e.g., alcohol or acetone) on the housing or
window – solvents may damage the finish or the window.

Inspecting Cords and Connectors

Inspect the interface cable and connector for wear or other signs of dam-
age. A badly worn cable or damaged connector may interfere with scanner
operation. Contact your distributor for information about cable replace-
ment. Cable replacement instructions are on

Replacing Cables

The standard interface cable is attached to the scanner with an 10-pin modular
connector. When properly seated, the connector is held in the scanner's handle
by a flexible retention tab. The interface cable is designed to be field replace-
able.
!
Caution:
housing is not watertight.
Customer
page 11-1.
11 - 1