Voip Call Protocol Setup - Planet VIP-281 Series User Manual

3. VoIP Call Protocol Setup

STEP 1 : Configure VoIP Call Signal Protocols :
User could select either H.323 or SIP Protocol, and click "select"
STEP 2 : Configure the numbering with phone/line ports
Phone Number
Line Number
STEP 3: Let VIP-GW register to Gatekeeper/SIP Proxy Server
Note: If user does not have Gatekeeper/SIP proxy server, please go to STEP 4: Outgoing Dialing Plan
Gatekeeper IP address
SIP Proxy Server IP
addresses
The representation number is the phone number of the telephone that
is connected to phone port
Line ports are connected to the extension ports of the PBX system or
the PSTN line. They have a common Line Hunting Group Number.
When this number is dialed, the VIP-GW system will find a free FXO
line connected to PBX. This hunting will skip all busy lines and absent
lines and find only the idle line to the PBX. After the available line is
found, you can hear the dial tone from PBX. After that, you can dial
the needed phone number out through PBX
There is a gatekeeper address fields. If this gateway does not
want to register to any gatekeeper, just set value 0.0.0.0 to the
primary Gatekeeper address.
There is a SIP proxy server address fields. If this VIP-GW does
not want to register to any SIP proxy server, just set value
0.0.0.0 to the sip proxy server address.
20