Connections - Hitachi KP-F1 Technical Operation Manual

6. Signal connection to connector
1) Signal connections to DC IN / SYNC connector (12 pins)
Internal External Sync Mode
Pin Sync
No. Mode HD/VD One Trigger Two Trigger Fixed Shutter Sync N.R.
1 Ground
2 + 12 volt input
3 Video 1 output Ground
4 Video 1 output Signal
5 HD in
Ground
6 HD in
Signal
7 VD in
Signal
8 Video 2 Output Ground
9 Video 2 Output Signal
10
11
12 VD In
Ground
Note:
The video signal cannot be fed simultaneously from both the VIDEO OUT connector and the
DC IN/SYNC connector. If both outputs are connected simultaneously, a proper picture
cannot be obtained.
The supply voltage should be 12 volts DC with a tolerance of ± 1 volt DC.
Plug :
DC IN/SYNC
Type: Hirose HR10-10P-12S(01)
Part Code: 23810AX
Field-on-Demand Mode
Trigger B In
Ground
Trigger B In
Signal
Trigger A In Trigger A In
Signal Signal
Ground
+12 Volt Input
Trigger A In Trigger A In
Ground Ground
Trigger A In Trigger A In
Signal Signal
Trigger A In
Ground
11