Advertisement
Step 3: Swing Wall Assembly
Note: Pre-drill all holes using a 1/8" drill
bit before installing the lag screws.
A: To 2 (F13) Posts attach 1 (F16) SW Ground with 4 (H2) 1/4 x 2" Hex Bolts (with lock washer, flat washer and
t-nut); 1 (F17) End Floor in the bottom holes and 1 (F14) Wall Support with 2 (H2) 1/4 x 2" Hex Bolts (with lock
washer, flat washer and t-nut) in each board. (fig. 3.1)
Fig. 3.1
B: Make sure assembly is square and then fasten (F17) End Floor to (F13) Posts in the top holes using 2 (LS1)
1/4 x 1-1/2" Lag Screws (with flat washer). (fig. 3.2)
C: Attach (F11) Lower Diagonal to (F16) SW Ground with 1 (H2) 1/4 x 2" Hex Bolt (with lock washer, flat washer
and t-nut) and to (F13) Post using 1 (LS3) 1/4 x 3" Lag Screw (with flat washer). (fig. 3.2)
D: Tighten all bolts.
Wood Parts
1 x
End Floor 1 x 5 x 38-1/4"
F17
1 x
SW Ground 1 x 5 x 77"
F16
1 x
Lower Diagonal 2 x 3 x 37"
F11
2 x
Post 2 x 4 x 83"
F13
1 x
Wall Support 1 x 4 x 38-1/4"
F14
Lag
Screw
Flat
Washer
F13
H2
F16
Fig. 3.2
F16
9 x
H2
LS3
1 x
2 x
LS1
Predrill Pilot Holes for Lag Screw
Predrill 1/8"
pilot hole
Use factory drilled
hole as a guide
H2
Notice hole
positioning
F13
F13
H2
Hardware
1/4 x 2" Hex Bolt
(1/4" lock washer, 1/4" flat washer, 1/4" t-nut)
1/4 x 3" Lag Screw
(1/4" flat washer)
1/4 x 1-1/2" Lag Screw
(1/4" flat washer)
13
Hex Bolt Assembly
Lock
Washer
Flat
He x
Washer
Bolt
H2
F14
F17
H2
LS1
LS3
F11
T- Nut
Advertisement
