Advertisement
Step 1: Rock Wall Assembly
Fig. 1.1
S2
F1
x 4 per
board
Bottom
A: Lay 2 (OR1) Rock Rails down, side by side with angled edges facing down. (fig. 1.1)
B: Place (F1) CE Access Board on the bottom of each (OR1) Rock Rail as shown in fig. 1.1. Make sure (F1) CE
Access Board is square and flush to the outside and bottom edges of each (OR1). Attach using 4 (S2) #8 x 1-1/2"
Wood Screws.
C: 8-1/8" down from the top of both (OR1) Rock Rails place 1 (F3) CE Rock Board, making sure the sides are
flush to the outside edges of each (OR1) Rock Rail. Attach using 4 (S2) #8 x 1-1/2" Wood Screws. (fig. 1.1)
D: In between the (F1) CE Access Board and (F3) CE Rock Board stagger 2 (F4) and 2 (F3) CE Rock Boards
using 4 (S2) #8 x 1-1/2" Wood Screws per board. Placing them as shown in (fig. 1.1), this will prevent rocks from
forming a straight line. Make sure the gap between boards are spaced 2-1/8" and does not exceed 2-3/8".
Fig. 1.2
E: Place 1 rock on each (F3) and (F4) CE Rock
Board (fig. 1.2) and attach using included hardware.
The screw must be in the hole directly under the Pan
Bolt, it will stop the rock from spinning. (fig. 1.3)
Wood Parts
1 x
CE Access Board 1 x 6 x 19-3/4"
F1
3 x
CE Rock Board 1 x 6 x 19-3/4"
F3
2 x
CE Rock Board 1 x 6 x 19-3/4"
F4
2 x
Rock Rail 2 x 3 x 51"
OR1
F4
F3
Note: Gaps between boards 2-1/8",
not to exceed 2-3/8"
24 x
F3
F4
Pan Screw
Hardware
#8 x 1-1/2" Wood Screw
S2
11
Note: The holes
F3
in the rock boards
OR1
must orient to the
top of the boards.
8-1/8"
approx.
Pan Bolt
Rock
Fig. 1.3
Other Parts
5 x Rocks (with hardware)
Lock
Washer
Flat
Washer
Barrel Nut
Advertisement
