Table of Contents
Advertisement
Installation
6
Installation Warnings:
!
Failure to follow all of the requirements may result in property damage, bodily
injury, or even death.
!
This heater must be installed by a qualified installer who has gone through a
training program for the installation of direct vent gas appliances.
!
This appliance must be installed in accordance with all local codes, if any; if not, in
U.S.A. follow ANSI Z223.1 and NFPA 54(88), in Canada follow B-149.
!
In Manufactured or Mobile Homes must confirm with: In USA, Manufactured Home
Construction and Safety Standard, Title 24 CFR, Part 3280; In Canada, CSA Z240.4
and Gas-Equipped Recreational Vehicles and Mobile Housing.
be installed in Manufactured Housing only after the home is site located.
!
The 36DV is designed to operate on natural gas, or propane (LP).
All exhaust gases must be vented outside the structure of the living-area.
Combustion air is drawn from outside the living-area structure.
!
Notify your insurance company before hooking up this fireplace.
!
The requirements listed below are divided into sections.
met simultaneously.
should follow the procedure best suited for the installation.
Packing List
•
Propane Conversion Kit
•
Log Set (Log Set & Coals)
•
Electrical Connector (3 wires - female molex)
•
Flex Tube with Pipe Adapter
•
Glass Latch Tool (to un-latch glass frame)
•
Arch Covers (for arched faces only)
Installation Overview
See "Power Heat
Vent" in the optional
equipment section.
Travis Industries
The order of installation
4-1/2" Min.
Drywall
Non-combustible facing
(see the section "Facing
Requirements")
See the section
"Mantel Requirements"
See the section
"Hearth Requirements"
See the section "Fireplace
Placement Requirements"
(for qualified installers only)
is not rigid – the qualified installer
Additional Items Required
•
Faceplate (gold or black) - Includes attachment screws
•
Direct Vent (Simpson Dura-Vent Ph. # 800 835-4429)
•
Gas Line Equipment (shutoff valve, pipe, etc.)
•
Electrical Equipment (min. 18 gauge, grounded line)
See the section
"Vent Requirements"
Nail
Down
Plate
See the section
"Gas Line Installation"
9 3 5 0 8 1 1 8
This appliance may
All requirements must be
See the section
"Horizontal Termination
Requirements"
See the
section
"Acceptable
Vent Lengths"
Insulation must not fill
the spaces between
the stand-offs
See the section
"Electrical
Connection"
See the section "Minimum
Framing Dimensions"
2 7 0 9 0 0
Advertisement
Table of Contents
