Table of Contents
Advertisement
Optional Equipment
2
Attach the blower box to the framing or floorboards of the home following the instructions below.
Wall or Ceiling Mounting
Cut a hole between wall
a
framing members for the
blower assembly.
16"*
5-1/4"
* This blower was designed for framing on 16"
centers - construct additional framing if needed.
Floor Mounting
Cut a hole between floor joists
a
for the blower box.
5-1/4"
Slide the blower into the hole
c
cut in step "a". Attach with four
screws.
Travis Industries
Attach the wall mounting
b
brackets to the blower box.
Attach the floor boot to the blower box with the included screws.
b
14"
9 3 5 0 8 1 1 8
(for qualified installers only)
Mount the bracket to
these holes for 2 x 4 walls
Mount the bracket to
these holes for 2 x 6 walls
Slide the blower, with
c
wires, into the hole cut
in step "a". Attach
with four screws.
The screws
attach to either
of these pairs of
holes. Use the
upper pair for
thick flooring, the
lower pair for
thin flooring.
2 7 0 9 0 0
4 7
Advertisement
Table of Contents
