Table of Contents
Advertisement
Notice
•
When the total FPS of all the recordings being
performed is around the following values, they may not
be performed according to the specifi ed settings.
When the total FPS is around the following values, you
cannot view images from the inactive cameras via the
network.
When the picture size is set to [4CIF] ........100 FPS
When the picture size is set to [2CIF] ........200 FPS
When the picture size is set to [CIF] ..........400 FPS
Tips
•
<Estimated time>
[Estimated time] is displayed at the bottom of the
•
screen, which shows the maximum continuous
recording time at the picture quality and FPS for
normal recording.
When you change the capacity of the normal
•
recording area in the partition setting, the estimated
time is displayed according to the specifi ed capacity.
The estimated time is just for a guide. Depending
•
on the recorded images, the actual recording time
may vary considerably. As more motion images are
recorded, the actual recording time may become
shorter than the estimated time.
•
When the sum of each FPS is around the following
values, [Total FPS] is displayed in red and an error
message appears. In this case, decrease the FPS.
When the picture size is set to [4CIF] ........100 FPS
When the picture size is set to [2CIF] ........200 FPS
When the picture size is set to [CIF] ..........400 FPS
•
[Total FPS] shows the sum of the larger values
between the FPS for normal recording and that for
alarm recording of the selected cameras. (The value
displayed in [Total FPS] is not same as the sum of the
displayed FPS.)
Alarm camera setting
10 Select recording cameras for each connected
Step
sensor.
Alarm recording is performed with selected cameras.
•
When an alarm signal is input during normal
•
recording, images from cameras selected for alarm
recording are recorded at the alarm recording
FPS rate while images from the other cameras are
recorded at the normal recording FPS rate. The
maximum total of the alarm recording FPS and
normal recording FPS of the selected cameras is as
follows.
When the picture size is set to [4CIF] ...... 100 FPS
When the picture size is set to [2CIF] .......200 FPS
When the picture size is set to [CIF] .........400 FPS
Alarm input to 3ch
1ch
Nomal recording
2ch
Nomal recording
3ch
Nomal recording
Alarm recording
4ch
Nomal recording
5ch
Nomal recording
6ch
Nomal recording
When the setting is completed, select [Next]. The
•
<Alarm input/output> screen is displayed.
Tips
•
You can select multiple cameras per sensor input.
Alarm input to 5ch
Nomal recording
Alarm recording
Nomal recording
Recording
57
Advertisement
Table of Contents
Troubleshooting
