Supervisor Password And Id; Supervisor Password; Supervisor Id - Patton electronics CopperLink 2160 Series Getting Started Manual

Model 2160 Series Getting Started Guide
You can set up the following options:
• Version: Set to Disable, Version 1 or Version 2.
• Trap host IP address: Enter the dtrap host IP address.
• Community: Enter the community password.
Use the list command to view all SNMP trap host entries.

Supervisor Password and ID

The supervisor ID and password is the last option in the security command menu, but it is the most important
menu item. Users who access the Model 2160 via a web browser or console/Telnet must use the supervisor ID
and password to configure the Model 2160. You should change the supervisor ID and password after initial
configuration.

Supervisor Password

To change the supervisor password, move the cursor " >>" to passwd in the security menu and press Enter.
The default password is root.
----------------------------------------------------------------------
Command: admin passwd <pass_conf>
Message: Please input the following information.
Input old Supervisor password: ****
Input new Supervisor password: ********
Re-type Supervisor password: ********
----------------------------------------------------------------------

Supervisor ID

To change the supervisor ID, move the cursor " >>" to id in the security menu and press Enter.
The default ID is root.
-----------------------------------------------------------------------------
Command: admin id <name>
Message: Please input the following information.
Legal user name (ENTER for default) <root>:
-----------------------------------------------------------------------------
Figure 35 on page 59 shows a flowchart of user access functions using the web browser or console/Telnet.
Administration Command Menu
Web Browser
Telnet/Console
5 • Console and Telnet configuration
ID Password
• •
•
94