Enable Command Menu - Patton electronics CopperLink 2160 Series Getting Started Manual

Model 2160 Series Getting Started Guide

Enable Command Menu

The enable command menu lists commands for setting up the Model 2160. Move the cursor " >>" to enable
and press Enter. Type the supervisor password, which is root.
----------------------------------------------------------------------
Command: enable <CR>
Message: Please input the following information.
Supervisor password: ****
----------------------------------------------------------------------
In the enable sub menu, you can set up management features and upgrade software, back up the system config-
uration and restore the system configuration via utility tools.
To save your changes, you must write the new configuration to NVRAM and reboot the Model 2160 to work
with the new settings.
When you first log in to the Model 2160 with the supervisor password, the main menu displays:
>> enable Modify command privilege
setup Configure system
status Show running system status
show View system configuration
write Update flash configuration
reboot Reset and boot system
ping Packet internet groper command
admin Setup management features
utility TFTP upgrade utility
exit Quit system
Table 16 explains the commands available in the main menu:
Command
enable Change the configuration and write changes to nonvolatile RAM (NVRAM).
setup Initially configure the Model 2160.
status View the status of the Model 2160
show Show the system and configuration
write Update flash configuration. After you have completed all desired changes, make sure to
write the new configuration to NVRAM. Use the write command to save your changes
and reboot the system or all of your changes will not take effect.
reboot Reset and reboot system. After you have completed all desired changes, make sure to write
the new configuration to NVRAM. Use the reboot command to restart the system or all of
your changes will not take effect.
ping Check the connection to the Model 2160
admin Set up advanced management features
utility Upgrade software and backup/restore the current configuration
exit Log out of the system

Enable Command Menu

Table 16. Enable Command Menu
Description
5 • Console and Telnet configuration
72