Reboot Command; Ping Command - Patton electronics CopperLink 2160 Series Getting Started Manual

Model 2160 Series Getting Started Guide

Reboot Command

The reboot command restarts the Model 2160. Move the cursor " >>" to reboot in the main menu and press
Enter.
----------------------------------------------------------------------
Command: reboot <CR>
Message: Please input the following information.
Do you want to reboot? (y/n): y
----------------------------------------------------------------------
Type "y" to begin the reboot process.

Ping Command

The ping command checks the connection of the Model 2160 to the network. Move the cursor " >>" to ping
in the main menu and press Enter.
The ping command sends an echo request packet to an address, and then waits for reply. The ping output can
help you evaluate path-to-host reliability, delays over the path, and whether the host can be reached or is func-
tioning correctly.
----------------------------------------------------------------------
Command: ping <ip> [1~65534|-t] [1~1999]
Message: Please input the following information.
IP address <IP> : 10.0.0.1
Number of ping request packets to send (TAB select): -t
Data size [1~1999]: 32
----------------------------------------------------------------------
There are 3 parameters for the ping command:
• IP address: Enter the IP address that you want to ping.
• Number of ping request packed to send: Use the TAB key to select the following options.
- Default: Sends 4 packets only
- 1~65534: Sets the number of ping request packets from 1 to 65534
- -t : Results run continuously until you press the Ctrl key to stop the process
• Data Size: Select from 1 to 1999

Reboot Command

5 • Console and Telnet configuration
89