Zero-Clearance Adjustable Trim Support - Quadra-Fire 31I-ACC Owner's Manual

3100-I ACC Wood Insert
L. Zero Clearance Adjustable Trim Support,
2" to 10"
Part No. 841-0990, size 9" x 45" and
Part No. ADJSPT-12, size 12" x 50"
Included in Kit: (
1) Trim Top, (1) Trim Front, (2) Trim Sides,
Double-Sided Tape (already installed)
Tools Needed:
Phillips Head Screwdriver, Sheet Metal
Shears, Measuring Tape, Gloves
1. The 10 screws on each set of scissors will already be
loose when shipped. Figure 44.1.
2. Expand scissors to desired height. Tighten screws
to hold in place using Phillips Head screwdriver. See
Figure 44.2.
3. Measure front and side trims to required height to
cover scissors and mark pieces for cutting.
excess material from top of trim's edge, not bottom.
This edge will be sharp; wear gloves to prevent injury
to your hands. Figure 44.2.
4. Using sheet metal shears, cut trim along the marked
edge. The cut edge fi ts under lip of top trim, so it allows
for some variance in your straight edge.
5. The double-sided tape that holds front and side trims
to scissors has a particularly powerful bonding adhe-
sive. Adjustments are extremely diffi cult once trim has
adhered to tape. Do a dry run fi rst without removing
paper from tape.
6. Place cut edge of trim under top lip and into position
on scissors. Place side pieces on fi rst and then front
piece. The front piece overlaps side pieces. NOTE:
The trim in the Flush Mount Kit is one piece.
7. Once you are satisfi ed with the positioning, remove
trim and set aside.
8. Remove the paper from double-sided tape that is
to accept trim side. Align side and then press hard
against tape to secure side piece. Repeat for other
side. Install front trim piece last.
9. There are 3 holes in the back fl ange of the top to secure
it to the wall if necessary. Use the appropriate fastener
for the type of wall material, i.e., brick, sheetrock, etc.
NOTE: 3/8" ( 9.5mm) thick tile or like material can be cut
to size and fi t under lip of top trim edge for a decora-
tive touch. Figure 44.3.
10. Thermal protection of 1-1/2 inches (38mm), "k" value of
0.49 and R value of 3.06 under the zero-clearance trim
support. Figure 44.4.
Page 44
Figure 43.1
EXPAND SCISSORS TO DESIRED HEIGH T
Cut
INSTALL FRONT TRIM LAST.
CORNERS OVERLAP SIDE
Figure 44.2
Figure 44.3
Figure 44.4
7044-140C
CUT TOP EDGE OF TRIM,
NOT BOTTOM EDGE
TRIM PIECES
Thermal
Protection
November 21, 2011
R
Decorative tile may
be installed