Diagnostic System; Access To The Diagnostic Cycle; Exiting The Diagnostic System - Electrolux EWM1100 Service Manual

4 DIAGNOSTIC SYSTEM

4.1 ACCESS TO THE DIAGNOSTIC CYCLE

1. Switch off the appliance.
2. Press and hold down the START/PAUSE button and the nearest OPTION button
simultaneously (as represented in figure).
3. Holding down both buttons, switch the appliance on by turning the programme selector one
position clockwise.
4. Continue to hold down the buttons until the LEDs begin to flash (at least 2 seconds).
In the first position, the cycle tests the operation of the buttons and the relative LEDs. If the
selector is turned clockwise, the cycle performs the diagnostics for the various components and
reads the alarm codes.
4.2

Exiting the diagnostic system

→ To exit the diagnostic system, switch off, switch on and switch off again the appliance.
2007-10 SOI/DT-mdm FCPD-dp Quality-fz
8/59
599 70 32-47