E61: Insufficient Heating During Washing - Electrolux EWM1100 Service Manual

E61
SOMETIMES THE ALARM CAN BE CAUSED BY THE POWER VOLTAGE TOO LOW!
Tests to be performed:
Measure the value of the
NTC sensor across contacts
J9-9 and J9-8 of the circuit
board connector.
Is the value correct?
(between 5.7 and 6.3 KΩ at
20°C)
YES
Replace the circuit board
and restart the diagnostic
cycle to check for further
alarm conditions.
If there are traces of burning on
the circuit board, refer to page
2007-10 SOI/DT-mdm FCPD-dp Quality-fz

E61: Insufficient heating during washing

Maximum heating time exceeded
Detach the connector and
measure the value directly
NO
on the NTC sensor.
Is the value correct?
- see fig. 14 -
(between 5.7and 6.3 KΩ at
Check/replace the wiring
and restart the diagnostic
cycle to check for further
alarm conditions.
59
Fig.4
NO
20°C)
YES
J10 J9
Circuit
board
42/59
Replace the NTC
temperature sensor and
restart the diagnostic
cycle to check for further
alarm conditions.
J7
J2
U3
599 70 32-47
E61
J1
fig. 14