Troubleshooting Based On Alarm Codes; E11: Water Fill Difficulty During Washing - Electrolux EWM10931 Service Manual

7 TROUBLESHOOTING BASED ON ALARM CODES

E11
Run the diagnostic cycle and fill all the trays with water (phases 2,3,4,5,6)
N
O
Is the drain pipe positioned
correctly and not causing the siphon
Is the washing machine's water
circuit efficient (leaking)?
Is the pressure switch's water circuit
efficient (leaking/clogged)?
Replace the main circuit board and repeat the diagnostic cycle to check for
Is one or are all the solenoid valves
not working?
Is the resistance measurement of the solenoid
valve approximately 3.5÷4.5kΩ? (Measure it
directly on the solenoid valve without wiring)
-(see fig.3)-
Reconnect the connector and measure
approximately 3.5÷4.5 KΩ on the solenoid
valve wiring connector on the circuit board side
-(fig.4)-: Between J7-1 and J7-3 wash
Between J7-4 and J7-6 pre-wash
Between J8-1 and J8-3 third solenoid valve
Between J8-4 and J8-6 hot water
Is the solenoid valve wiring ok?
Replace the main circuit board and repeat
the diagnostic cycle to check for any
further alarms.
2011 SOE/DT-mdm FCPD-dp Quality-tb
Guide to diagnostics of electronic controls EWM10931

E11: Water fill difficulty during washing

Maximum water fill time for every level of the pressure switch
(the time is reset every time the level is achieved)
Are all the trays filling with water?
Y
E
S
effect? -(fig.1)-
Y
E
S
Y
E
S
-(fig.2)-
Y
E
S
Y
E
S
Y
E
S
Y
E
S
!
Check that all the connectors are correctly inserted
Repair the drain circuit and repeat
the diagnostic cycle to check for any
NO
Repair the water circuit and repeat
the diagnostic cycle to check for any
NO
Repair the water circuit of the pressure switch
and repeat the diagnostic cycle to check for
NO
any further alarms.
any further alarms.
Check whether the tap is open, if the
water pressure is too low and make sure the
NO
tubes are connected and not kinked
Replace the solenoid valve and repeat
the diagnostic cycle to check for any
NO
Replace/repair the wiring and repeat
the diagnostic cycle to check for any
NO
If there are burns on the circuit
!
20/75
further alarms.
further alarms.
further alarms
further alarms.
board, see page 73
599 73 77-37
E11