E61: Insufficient Heating During Washing - Electrolux EWM25 series Service Manual

E61
Checks to perform:
Measure the value of the
NTC sensor across contacts
J9-9 and J9-8 of the circuit
board connector.
Is the value correct?
(between 5.7 and 6.3 KΩ
at 20°C)
YES
Replace the circuit board
and restart the diagnostic
cycle to check for further
alarms.
5.7 ÷ 6.3KΩ 5.7 ÷ 6.3KΩ 5.7 ÷ 6.3KΩ
(20°C) (20°C) (20°C)
Temperature probe
5.7 ÷ 6.3KΩ
(20°C)
07-2010 SOI/DT-mdm FCPD-dp Quality-fz

E61: Insufficient heating during washing

Maximum heating time exceeded
SOMETIMES THE ALARM CAN BE CAUSED
BY THE POWER VOLTAGE TOO LOW!
Check that all the connectors are inserted correctly
Detach the connector and
measure the value directly
on the NTC sensor.
NO
Is the value correct?
– (see fig. 14) –
(between 5.7and 6.3 KΩ
Check/replace the wiring
and restart the diagnostic
cycle to check for further
Fig.4
Circuit
board
Heating element
NO
at 20°C)
YES
alarms.
If there are traces of burning on the
circuit board, refer to pages
71/121
E61
Replace the NTC
temperature sensor and
restart the diagnostic
cycle to check for further
alarms.
119-120
Fig. 14
599 70 99-00