Chevrolet Silverado Classic 2007 Owner's Manual page 63

CAUTION:
{
Children can be seriously injured or
strangled if a shoulder belt is wrapped
around their neck and the safety belt
continues to tighten. Secure any unused
safety belts behind the child restraint
so children cannot reach them. Pull the
shoulder belt all the way out of the
retractor to set the lock, if your vehicle
has one, after the child restraint has
been installed. Be sure to follow the
instructions of the child restraint
manufacturer.
Notice: Contact between the child restraint or
the LATCH attachment parts and the vehicle's
safety belt assembly may cause damage to
these parts. Make sure when securing unused
safety belts behind the child restraint that
there is no contact between the child restraint
or the LATCH attachment parts and the
vehicle's safety belt assembly.
Folding an empty rear seat with the safety
belts secured may cause damage to the
safety belt or the seat. When removing the
child restraint, always remember to return
the safety belts to their normal, stowed
position before folding the rear seat.
Regular Cab Models
1. If the child restraint manufacturer recommends
that the top tether be attached, attach and
tighten the top tether to the top tether anchor,
if your vehicle has one. Refer to the child
restraint instructions and the following steps:
1.1. Pull the passenger seatback forward
by pulling the recliner handle upward
to access the top tether anchor.
See Reclining Seatbacks on page 14
for additional information.
1.2. Find the top tether anchor.
1.3. Remove the trim cover to expose
the anchor.
63