Check Oil Level; Driver Door Ajar; Engine Coolant Hot; Check Washer Fluid - Chevrolet Silverado Classic 2007 Owner's Manual

CHECK OIL LEVEL

If your vehicle has an oil level sensor, and the
oil level in the vehicle is low, this message
will appear on the DIC. Check the oil level and
correct it as necessary. You may need to let
the vehicle cool or warm up and cycle the
ignition to be sure this message will clear.
Once the problem is corrected, pressing any
of the four DIC buttons will acknowledge
the message and clear it from the DIC display.
If your vehicle does not have the four DIC
buttons, pressing the trip odometer reset stem
will acknowledge the message and clear it from
the DIC display. See Engine Oil (Gasoline Engine)
on page 486 for additional information.

CHECK WASHER FLUID

If the washer fluid level is low, this message will
appear on the DIC. See Windshield Washer Fluid
on page 515. Adding washer fluid to the windshield
washer reservoir will clear the message. Pressing
any of the four DIC buttons will acknowledge the
message and clear it from the DIC display. If your
vehicle does not have the four DIC buttons, pressing
the trip odometer reset stem will acknowledge the
message and clear it from the DIC display.
272

DRIVER DOOR AJAR

If the driver's door is not fully closed, this message
will appear on the display and you will hear a
chime. Stop and turn off the vehicle, check the
door for obstructions, and close the door again.
Check to see if the message still appears on the
DIC. Pressing any of the four DIC buttons will
acknowledge the message and clear it from the
DIC display. If your vehicle does not have the
four DIC buttons, pressing the trip odometer reset
stem will acknowledge the message and clear it
from the DIC display.

ENGINE COOLANT HOT

If the cooling system temperature gets hot, this
message will appear in the DIC. Turn off the air
conditioning. If the message is still on, or if the
engine coolant temperature gage continues to rise,
pull the vehicle over when it is safe to do so. See
Engine Coolant Temperature Gage on page 255
for more information. Stop the vehicle and let
the engine idle in PARK (P) for a few minutes,
or NEUTRAL with the parking brake set for manual
transmissions, to allow the coolant to reach a safe
temperature. This message will clear when the
coolant temperature drops to safe operating
temperature.