Table of Contents
Advertisement
4-8 Windows Setup
As for physical format, refer to "SAS BIOS – SAS Configuration Utility –" in
Chapter 4, "System Configuration" in the separate volume of the User's Guide, and
perform Format Disk with Disk Utilities.
For how to configure the settings, see "System BIOS – SETUP –" in Chapter 4
"System Configuration" in the separate volume of the User's Guide.
Prepare the installation from the CPU/IO module 0. Mount a HDD to the designated place
2.
when installing the OS.
The location of the parts required for operation and checking are shown below:
Mount only one HDD here
when you install/reinstall OS.
DISK ACCSSS LED
CPU/IO module 0
Front side of device
Rear side of device
Status LED
POWER switch
CPU/IO module 1
DUMP (NMI)
Switch
AC Inlet
Connector A
AC Inlet
Connector B
Advertisement
Table of Contents
Troubleshooting
