NEC N8800-155F User Manual page 112

4-58 Windows Setup
Verify that disk synchronization has started and the status of the DISK ACCESS LED and
9.
RDR Utility display changes as the following table.
■ During synchronization
Synchronization
source disk
Synchronization
destination disk
RDR Virtual Disk
IMPORTANT:
The time required for synchronization varies depending on the partition
size on the disk. For a 73GB partition, it takes about 80 minutes. When
the partition does not exist on the disk, the synchronization is completed
immediately after the RDR is set, and Op State: State changes to Duplex.
However, when the dynamic disk is used, the time required for
synchronization depends on the disk size regardless of whether or not the
partition exists on the disk. For a 73GB disk, it takes about 80 minutes.
Setting dual disk configuration may not complete if you reboot the
system during the synchronization. Do not reboot the system before
synchronization process completes.
If the system stops by improper termination of Windows such as
pressing the power button, the entire synchronized disk area will be
resynchronized after rebooting the system.
DISK ACCESS LED
Green and blinking
Amber and blinking
－
RDR Utility
Condition
Online
Syncing
Simplex Resync x %
(x = 0,4,8,..., 96)
Status
-
-