Table of Contents
Advertisement
Manual MMS Setup
Text to send
#145#
#124#MMScenter#
#125#parameters#
#55#
#54#
MASTER & USER
Up to 10 Users set up by the Master can access YOYOCam. Master and Users can send these
commands. Master & Users can also call YOYOCam and listen in via the built-in microphone.
Most Common Commands
Text to send
What it does
#01#
Arm YOYOCam (if an event is detected, alarm is triggered)
#02#
Disarm YOYOCam (events will be ignored)
#03#
Take one image and send it to the requesting user
#03#Quantity#
Take a number (Quantity 1-8) of images and send to requestor
#07#
Check the settings and status
#09# or #09#1#
Get the command list (#09# for SMS, #09#1# for MMS response)
#32#Size#
Set image size: 1: 160x128; 2: 320x240 (default); 3: 640x480
#33#Quantity#
Set quantity of images to take when triggered: 1-8 (default 3; note 1)
#118#0# or #118#1#
Disable (0) infrared body detection; enable (1) (default)
#22#0# or #22#1#
Disable (0) camera based motion detection (default); enable (1)
#39#0#
Call mode – When Emergency button pressed, numbers are dialed
#39#1#
SMS/MMS mode – when Emergency button is pressed, YOYOCam
sends SMS and MMS.
#143#0# or #143#1#
Disable (0) indicator LED; enable (1) (default)
NOTE: Quantity (image quantity) is in range 1-8 for image sizes 160 x 120 and 320 x 240. Quantity
must be 1-2 for image size 640 x 480.
Arming & Disarming
Text to send
#01#
#02#
#137#0# or #137#1#
#129#parameters#
#128#0# or #128#1#
#139#Times#
#138#0# or #138#1#
What it does
Get this list or virtual operators with Quick-Command setup.
Set MMS Centre
Set MMS Access Point and parameters
#125#GatewayIP#WAPGatewayPort#HTTPGatewayPort#APN#APNus
ername#APNpassword#
Check MMS parameters
Delete current MMS parameters; YOYOCam reverts to auto-
configuration mode.
What it does
Arm YOYOCam (if an event is detected, alarm is triggered)
Disarm YOYOCam (events will be ignored)
Receive an SMS when remote control arms/disarms YOYOCam.
0: Off (default); 1: On
Set arm and disarm state by a schedule based on day and time
#129#Day#ArmTime1#DisarmTime1#ArmTime2#DisarmTime2
#ArmTime3#DisarmTime3#
Disable (0) (default) above scheduled arm/disarm state; enable (1).
Auto-disarm after Times the alarm has been triggered
Disable (0) (default) auto-disarm; enable (1).
50
Advertisement
Table of Contents
