Wiring The Fan - Hunter 42015-01 Installating And Operation Manual

5 • Wiring the Fan
Steps 5-3 – 5-7
Wire Nut
8
Hunter Fan Company
All wiring must be in accordance with national and local electrical
codes and ANSI/NFPA 70. If you are unfamiliar with wiring, use a
qualified electrician.
Antenna
5-1. Disconnect the power by turning off the circuit breakers to the
outlet box and associated wall switch location.
5-2. To connect the wires, hold the bare metal leads together and place
a wire nut over them, then twist clockwise until tight. For all these
connections use the larger wire nuts provided.
CAUTION: Be sure no bare wire or wire strands are visible after
making connections.
5-3. Connect the ground wire from the ceiling to the green ground
wire from the hanger bracket and the green ground wire from the
downrod.
5-4. Connect the white and black wires from the ceiling as follows::
• e white (common) power wire from the ceiling to the white
wire from the receiver (marked on red tag "NEUTRAL IN")
• e black power wire from the ceiling to the black wire from
the receiver (marked on red tag "LIVE IN")
5-5. Connect the wires from the fan as follows:
• e black/white wire from the fan to the red wire from the
receiver (marked on white tag "LIGHT OUT")
• e black wire from the fan to the black wire from the receiver
(marked on white tag "FAN OUT")
• e white wire from the fan to the white wire from the receiver
(marked on white tag "COMMON OUT")
5-6. Push all wires and wire nuts back through the hanger bracket hole
into the outlet box.
5-7. Run the white antenna wire from the receiver through one of the
slots in the hanger bracket so that it rests between the hanger
bracket and the ceiling. Push it to the edge of the hanger bracket
for clear reception.
42015-01 • 02/15/05