Setting The Remote Transmitter And Receiver - Hunter 42015-01 Installating And Operation Manual

You must now set the jumper switches in the remote transmitter and
receiver so that they match.
4-1. Change the position of the jumper switches in the transmitter
and the receiver. Be sure the position of the jumper switches
matches. If they don't match, the controller will not function.
For instructions on how to set the jumper switches, read the box
below.
4-2. Install the included 12-volt battery into the transmitter.
Setting Jumper Switches
When two or more fans are located near each other, you may desire to have the
receiver/transmitter for each fan set to a diff erent code, so that the operation of
one fan does not aff ect the operation of the other fans.
In the transmitter you can access the jumpers from the battery compartment.
 e jumpers are very small. You can move them most easily using a small pair of
pliers or tweezers. IMPORTANT! Before you change jumper switches, make sure
the battery is not connected to the transmitter.
CAUTION:  e remote control device complies with part 15 of the FCC rules.
Changes or modifi cations not expressly approved by Hunter Fan Company could void
your authority to operate this equipment.
Operation is subject to the following two conditions:
1.  is device may not cause harmful interference.
2.  is device must accept any interference received, including interference that may
cause undesired operation.
Note: Use with a fan that incorporates an air gap switch (normal on-off wall switch).
WARNING: Maximum fan load is 1 Amp; maximum lamp is 100 Watts. Do not use
any speed control with this product.
42015-01 • 02/15/05
4 • Setting the Remote Transmitter and Receiver
7
Hunter Fan Company