3 • Assembling and Hanging the Fan . . . 6 4 • Wiring the Fan ..... 7 5 • Installing the Canopy....8 6 •...
Page 3
Understanding Mounting and Installer’ s Choice® Hunter’s patented 2-position mounting system provides you maximum installation flexibility and ease. You can install your Hunter fan in one of two ways, depending on ceiling height and your preference: Standard or Angled mounting. The steps in this manual include instructions for both Installer’s Choice mounting methods.
• Drill holes for and install wood screws. • Identify and connect electrical wires. • Lift 40 pounds. If you need help installing the fan, your Hunter fan dealer can direct you to a licensed installer or electrician. Gathering the Tools You will need the following tools for installing the fan: •...
Tighten the screws into the 9/64” pilot holes; do not use lubricants on the screws. Do not over tighten. Flat Washer 42786-01 • 08/14/09 • Hunter Fan Company 3” Wood Screw For Angled Ceilings: Be sure to orient the ceiling plate so that the arrows printed on the ceiling plate are pointing toward the ceiling peak.
3-1. Unbundle the wires from the fan. For Standard or Angle mounting: 3-2. To assemble fan to hang down from a flat or angled ceiling, insert the downrod through the canopy. Feed the wires from the fan through the downrod.
4-7. Spread the wires apart, with the grounded wires on one side of the outlet box and the ungrounded wires on the other side of the outlet box. 42786-01 • 08/14/09 • Hunter Fan Company 4 • Wiring the Fan fsdfsdf...
5-5. Install the third canopy screw into the canopy. Once all three screws are in, tighten them. 5-6. Lift the fan housing toward the ceiling and rotate the fan until each canopy tab engages a groove in the hanger ball.
Hunter fans use several styles of fan blade irons (brackets that hold the blade to the fan). 6-1. Your fan may include blade grommets. If your fan has grommets, insert them by hand into the holes on the blades. 6-2. Attach each blade to a blade iron using three blade assembly screws.
7 • Completing Your Installation With a Bowl Light Fixture Your Hunter fan comes with an integrated light fixture assembly. WARNING: Use only the light fixture supplied with this fan model. The switch housing assembly is made up of three sections: the switch housing gasket, the upper switch housing, and the lower switch housing/ light assembly.
7-11. Turn the lower switch housing clockwise until the housing assembly screws are firmly situated in the narrow end of the keyhole slots. 7-12. Tighten all housing assembly screws. 42786-01 • 08/14/09 • Hunter Fan Company Step 7-5 Spokes Step 7-7...
Page 12
(You may find the plastic breakaway connector on the end of the extra chain.) 7-15. Thread the fan pull chain (coming from the side of the light kit) down through the closest hole in the metal disc. Then, thread the fan chain through the bottom of the glass bowl, and finally through the grommet hole in the cover plate.
8 • Operating and Cleaning Your Ceiling Fan 8-1. Turn on electrical power to the fan. 8-2. The fan pull chain controls power to the fan. The pull chain has four settings in sequence: High, Medium, Low and Off. • Pull the chain slowly to change settings.
Problem: If the light on this fan shuts off suddenly. 1. Turn the power to the fan off at the wall switch. Wait 30 seconds, then resume power to the fan. 42786-01 • 08/14/09 • Hunter Fan Company 9 •...