Assembling And Hanging The Fan - Hunter 42015-01 Installating And Operation Manual

3 • Assembling and Hanging the Fan
Standard
Mounting
Washer
Step 3-1
Steps 3-2 – 3-4
6
Adapter
Hunter Fan Company
You can assemble your fan for standard or angle mounting as shown
Label
in steps 3-1 – 3-6.
3-1. Remove the label from the standard mounting washer inside the
canopy. Leave the washer in place.
3-2. To assemble fan to hang down from a flat or angled ceiling, place
the canopy with washer, and canopy trim ring around the adapter
so that they rest on the fan assembly.
3-3. Feed the wires from the fan through the downrod.
3-4. Screw the downrod into the fan assembly. Tighten the allen head
set screw using the included allen wrench.
CAUTION: e downrod has a special coating on the threads.
Canopy
Do not remove this coating; the coating prevents the downrod from
unscrewing. Once assembled, do not remove the downrod.
WARNING: Do not carry or lift fan by canopy.
Downrod 3-5. Raise the fan and place the ball into the hanger bracket.
3-6. Align the notch on the ball with the indent in the hanger bracket.
(Rotate the fan until you hear the notch pop into place.)
Canopy
(with Washer)
WARNING: Fan may fall if not assembled as directed in these
installation instructions.
Canopy
Trim Ring
Set Screw
Steps 3-5 – 3-6
Indent
42015-01 • 02/15/05