Page 3
To install and use the accessories, follow the instructions included with each product. For quiet and optimum performance of your Hunter fan, use only Hunter speed controls. CAUTION: To reduce the risk of personal injury, attach the fan directly...
• Drill holes for and install wood screws. • Identify and connect electrical wires. • Lift 40 pounds. If you need help installing the fan, your Hunter fan dealer can direct you to a licensed installer or electrician. Gathering the Tools You will need the following tools for installing the fan: •...
Tighten the screws into the 9/64” pilot holes; do not use lubricants on the screws. Do not over tighten. Flat Washer 42859-01 • 04/24/09 • Hunter Fan Company Hanger Bracket Canopy Screw Isolator 3”...
Ground Wire Step 3-3 #8-32 x 1” Screw 42859-01 • 04/24/09 • Hunter Fan Company 3-1. Position the square hanger so that the green ground wire attached to the square faces out of the large opening in the metal bracket.
4-7. Spread the wires apart, with the grounded wires on one side of the outlet box and the ungrounded wires on the other side of the outlet box. 42859-01 • 04/24/09 • Hunter Fan Company 4 •Wiring the Fan Wire...
Rotate the fan housing to situate the screws in the narrow ends of the keyholes. 5-3. Install the two remaining canopy screws into the holes in the fan housing and into the hanger bracket. Securely tighten all screws.
Hunter fans use several styles of fan blade irons (brackets that hold the blade to the fan). 6-1. Install the grommets into the blades by hand. 6-2. Place each blade between a blade iron and medallion. Install three blade screws to attach the medallion to the blade iron. Repeat for all blades.
7 • Completing Your Installation With or Without a Bowl Light Fixture Your Hunter fan comes with an integrated light fixture assembly and an optional switch housing cap and plug button. This feature gives you the option of installing the fan with OR without the included light fixture.
Page 11
Align the side screw holes in the upper and lower switch housings. Attach the lower switch housing to the upper switch housing with three housing assembly screws. 42859-01 • 04/24/09 • Hunter Fan Company Steps 7-6 – 7-7 Lower Switch...
Page 12
(You may find the plastic breakaway connector on the end of the extra chain.) 7-10. Thread the fan pull chain through the hole in the metal disk. Then, thread the fan pull chain through the hole in the center of the glass bowl.
Page 13
7-22. Once you have uninstalled the light fixture, continue with step 7-6. Male Dummy Terminal Female Dummy Terminal 42859-01 • 04/24/09 • Hunter Fan Company Lower Switch Threaded Rod Steps 7-17 – 7-19 Plug Button Housing Step 7-21...
8 • Operating and Cleaning Your Ceiling Fan 8-1. Turn on electrical power to the fan. 8-2. The fan pull chain controls power to the fan. The pull chain has four settings in sequence: High, Medium, Low, and Off. • Pull the chain slowly to change settings.
1. If your fan wobbles when operating, use the enclosed balancing kit and instructions to balance the fan. 2. Tighten all blade and/or blade iron screws. 42859-01 • 04/24/09 • Hunter Fan Company 9 • Troubleshooting If you need parts or service assistance, please call 888-830-1326 or visit us at our Web site at http://www.hunterfan.com.