Using Handsfree Speakerphone; Using A Headset - Aastra 6865i User Manual

Making Calls

Using Handsfree Speakerphone

The handsfree feature allows you to speak to someone without using the handset or headset. Your phone must be in
either the Speaker or Speaker/Headset audio mode. For more information about setting the audio mode on your
phone, see "Audio Mode" on
IP Phone UI
• To dial using handsfree, first press
• To answer a call on your phone using handsfree, press
• If you are in Speaker audio mode, lift the handset and press
• If you are in Speaker/Headset audio mode, press
• When the handset is on hook, press
Note:
When handsfree is on, the speaker light turns on.

Using a Headset

The 6865i accepts headsets through the modular RJ22 jack on the back of the phone. Contact your telephone equip-
ment retailer or distributor to purchase a compatible headset.
Important!
• The headset port is for headset use only. Plugging any other devices into this port may cause damage to the phone
andwill void your warranty.
• Customers should read and observe all safety recommendations contained in headset operating guides when using
any headset.
Volume Controls for the Headset Microphone
On the 6865i, there are three options for the headset microphone volume: Low, Medium, and High. For information
about configuring the headset microphone volume, see
Making and Receiving Calls Using a Headset
IP Phone UI
1. Ensure that you have selected a headset audio mode (see
Turn the phone over and locate the headset jack marked f.
2.
If you have a headset with an RJ9/RJ22 4-pin connector, insert the headset cord into the jack until it clicks into place.
If you have a DHSG/EHS headset with an RJ45 6-pin or 8-pin connector, remove the plastic headset jack adapter and
then insert the cord into the jack until it clicks into place.
Note:
See the Aastra 6865i SIP IP Phone Installation Guide for more information.
3. Press the key to obtain a dial tone or to answer an incoming call. Depending on the audio mode selected
from the Options List, a dial tone or an incoming call is received on either the headset or the handsfree speakerphone.
4. Press the key to end the call.
98
.
page 24
and enter a number at the dial tone.
to disconnect the call.
"Headset Mic Volume"
"Audio Mode"
or the line/call appearance button.
to switch between handsfree and handset.
to switch between handsfree and headset.
on page 25
on page 24.
.
41-001523-00 REV00 – 04.2014