Chapter 1 Overview; Dhcp Assigned Ip Addresses - Proliphix IMT350c Configuration Manual

Beta Draft Confidential
Overview
This chapter gives an overview of the Proliphix Internet Managed Thermostats (IMT)
Series Network Thermostats, as well as how to access the IMT350 using a Web
browser.
The IMT350 series of thermostats are powered by either Proliphix Ethernet Power
Adapters, Power over Ethernet, or via 24Vac from the HVAC system, and include the
following features:
Table 1-1 IMT350 Features

DHCP Assigned IP Addresses

The IMT350c and IMT350w thermostat ship directly from the factory enabled to
perform as a Dynamic Host Configuration Protocol (DHCP) client. DHCP is an
established standard used to assign IP addresses automatically after each network
device is inserted into the network or when the device experiences a power cycle.
DHCP allows devices on your local network to receive their Internet Protocol (IP)
addresses automatically from an attached DHCP server typically located within a
local router.
If your file server or router supports DHCP, then your Proliphix thermostat
automatically retrieves an IP Address, Gateway Address, Subnet Mask, and DNS
server address from the DHCP server on your network.
Internet Management Thermostat Configuration Guide, Release 1.0
Part No. 600-03001-350, Rev. 1
Model Wired
Ethernet
IMT350c X
IMT350w
802.11 b/g Humidity
wireless Sensing
X
X X
1
Chapter
Aux Relays Power
(2) Method(s)
EPA
X
PoE
HVAC
HPA
X
HVAC
1-1