Burner Assembly And Gas Conversion; Gas Valve - GE CleanSpeak GTD81ESPJMC Technical Service Manual

Burner Assembly and Gas Conversion

The burner assembly consists of the gas valve with
attached gas inlet pipe, gas valve coils, and burner.
To convert the dryer from natural gas to LP gas,
refer to conversion kit (Part #: WE25M87). To convert
the dryer from LP gas to natural gas to, refer to
conversion kit (Part #: WE25M88).

Gas Valve

The gas valve is attached to the burner bracket.
Gas Valve Removal
1.
2. Remove the front bulkhead. (See Front Bulkhead
Removal in this guide.)
3. Disconnect the ignitor wire harness.
4. Disconnect the wire harness from both coils.
5. Remove the wire retainer from the front of the
burner bracket.
Burner Bracket
Disconnect
Disconnect
Disconnect
Wire Retainer
– 29 –
6. Remove the two 1/4 in. hex head screws from
the front of the burner bracket.
7. Pull the burner and the connected gas inlet pipe
as an assembly out from the dryer.
8. Remove the three 1/4 in. hex head screws that
attach the gas valve to the burner bracket.