Adjustable Hearth Support - Quadra-Fire SANTAFEI-MBK Owner's Manual

Santa Fe Pellet Insert
F. Adjustable Hearth Support
Size: 9"d x 45"w, 2" to 10" Height Adjustment
Included in Kit: (1) trim top, (1) trim front, (2) trim sides,
double-sided tape (already installed)
Tools Needed: Phillips head screwdriver, sheet metal
shears, measuring tape, gloves
1. The 10 screws on each set of scissors will already be
loose when shipped. Figure 20.1.
2. Expand scissors to desired height. Tighten screws to
hold in place using Phillips head screwdriver. Figure
20.2.
3. Measure front and side trims to required height
to cover scissors and mark pieces for cutting. Cut
excess material from top of trim's edge, not bottom.
This edge will be sharp; wear gloves to prevent injury
to your hands. Figure 20.3.
4. Using sheet metal shears, cut trim along the marked
edge. The cut edge fits under lip of top trim, so it
allows for some variance in your straight edge.
5. The double-sided tape that holds front and side trims
to scissors has a powerful bonding adhesive. Adjust-
ments are extremely difficult once trim has adhered to
tape. Do a dry run first without removing paper from
tape.
6. Place cut edge of trim under top lip and into position
on scissors. Place side pieces on first and then front
piece. The front piece overlaps side pieces.
7. Once you are satisfied with the positioning, remove
trim and set aside.
8. Remove the paper from double-sided tape that is
to accept trim side. Align side and then press hard
against tape to secure side piece. Repeat for other
side. Install front trim piece last.
9. There are 3 holes in the back flange of the top to
secure it to the wall if necessary. Use the appropriate
fastener for the type of wall material, i.e., brick, sheet-
rock, etc.
NOTE: 3/8 inch (9.5mm) thick tile or like material can
be cut to size and fit under lip of top trim edge for a
decorative touch. Figure 20.3.
WARNING
Sheet metal trim edges will be sharp.
For safety purposes wear gloves.
Injury can occur.
Page 20
EXPLODED VIEW OF SCISSORS
DOUBLE-SIDED TAPE
Figure 20.1
EXPAND SCISSORS TO DESIRED HEIGHT
INSTALL FRONT TRIM LAST.
CORNERS OVERLAP SIDE
TRIM PIECES
Figure 20.2
Figure 20.3
Figure 20.4
7019-221D
SCREWS ARE CIRCLED
DOUBLE-SIDED TAPE
CUT TOP EDGE OF TRIM,
NOT BOTTOM EDGE
Decorative tile
may be installed
January 21, 2013
R